2016年8月4日星期四

The tips of ICOM A2 WinKFP Error 211 on Flash Programming

The tips of ICOM A2 WinKFP Error 211 on Flash Programming

How to solve the problem of ICOM A2 siftware WinKFP Flash Programming Error 211? There are some tips shared by our customers. Hope it useful!

Q: Both modules from the BMW dealership comes With VIN & Part Number already programmed in them but when use INPA to read the UIF block,the part number only showed up but not the VIN.number, in its place is all yyyyyyy.

What is the proper procedure to use WinKFP to program both the CAS & DME to facilitate a starting the engine for BMW E60?


The tool you need: BMW ICOM A2 (note: laptop with windows XP)

1.You only need to code both units and then align. this can be done via NCS and INPA. When units are virgin chassis is written at time of coding.

2.Just code both modules to default. You can use any profile which has manipulation disabled.

3.Modules on the MOST bus should be reprogrammed with an ICOM interface and not a K+DCAN cable.

4.You should be able to successfully reprogram it with ISTA/P and an ICOM interface.

5.Check your Winkfp configuration, make sure it looks like this.


6.Didn't have the power supply connected with the right volts.

没有评论:

发表评论